Nortel Networks Control Clamp EMC Bedienungsanleitung PDF herunterladen

209823-A

June 2000

Installing the EMC Control Clamp

The EMC Control Clamp must be placed no further than 3.7 cm. (1-1/2 inches)

from the connector located on the PCMCIA card. The cable must pass through the

clamp three times to function properly.

To attach the EMC Control Clamp to the Ethernet cable, follow these procedures:

1. Open the clamp by placing your thumb

nail into the side of the clamp that has

the edge on it. Pull out and lift the top of

the clamp.

2. Place the Ethernet cable through the

center of the clamp. Adjust the cable to

make sure you are within 3.7 cm (1-1/2

inches) of the PC card connector.

3. Holding the cable in the clamp with your

thumb, wrap the Ethernet cable around

and through the center of the clamp two

more times.

4. Hold the Ethernet cable together in the

center of the clamp and close the clamp

until it snaps shut.

5. Connect the cable to the port on the

PCMCIA card.

1 2

Inhaltsverzeichnis

Seite 1 - June 2000

209823-AJune 2000Installing the EMC Control ClampThe EMC Control Clamp must be placed no further than 3.7 cm. (1-1/2 inches) from the connector locate

Seite 2 - '5F

'5F

Kommentare zu diesen Handbüchern

Keine Kommentare

Nortel Networks Control Clamp EMC Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Nein Nortel Networks Control Clamp EMC herunter. Nortel Networks Control Clamp EMC User's Manual [en] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Nortel Networks Control Clamp EMC