Nortel-networks Media Dependent Adapter Bedienungsanleitung PDF herunterladen (Seite 15)

Installing an MDA

The Uplink Module slot on the BayStack 450 switches

accommodates a single MDA. The connection can be

either an RJ-45 10/100BASE-TX MDA or a fiber

(100BASE-FX or 1000BASE-SX/LX) MDA with an SC

or PHY connector.

To install an MDA into the Uplink Module slot, follow

these steps:

1. Unplug the AC power cord from the back of the

switch.

2. Loosen the thumbscrews and remove the filler

panel (or previously installed MDA) from the

Uplink Module slot.

Note:

Installing or removing an MDA from an

operating switch (hot-swapping) causes the switch to

auto-reset as soon as the insertion or removal of the

device is sensed by the switch software. Although the

switch is hot-swap survivable, data integrity during

the reset will be compromised.

1 2 ... 10 11 12 13 14 15 16 17

Keine Kommentare

Nortel-networks Media Dependent Adapter Bedienungsanleitung Seite 15