Nortel Networks ROADSTER 56K Bedienungsanleitung PDF herunterladen (Seite 12)

NetComm Roadster Series 56K USB Modem YML5067YML50675067

12 www.netcomm.com.au

P - Select Pulse Dialing

Use this command to congure the modem for pulse dialing. All subsequent

D<dial_string> commands use pulse dialing until either the T command or a tone dial modier is received by the modem. Tone dialing is the

default setting.

This command does not use parameters and generates an ERROR result code when parameters are attached to the command.

Q<value> - Result Code Control

Result codes are informational messages sent from the modem and displayed on the monitor. Basic result codes include OK, CONNECT,

RING, NO CARRIER, and ERROR. Use the Q<value> command to enable or disable

result code generation by the modem. If result codes are disabled and an invalid parameter value is entered, the modem does not generate

an ERROR result code because result codes are turn off.

Result codes:

_ OK if <value> = 0—1.

_ ERROR if <value> 0—1.

T - Select Tone Dialing

Use this command to congure the modem for DTMF tone dialing. All subsequent D<dial string> commands use tone dialing until either the

P command or a pulse dial modier is received by the modem. Tone dialing is the default setting. This command does not use parameters

and generates an ERROR result code when parameters are attached to the command.

W<value>—Result Code Option

Use this command to select the modems CONNECT message options.

Result codes:

_ OK if <value> = 0—2.

_ ERROR if <value> 0—2.

Command Function

CONNECT result code reports DTE receive speed. Disables protocol result codes.

CONNECT result code reports DTE receive speed. Enables protocol result codes.

CONNECT result code reports DCE receive speed. Enables protocol result codes (default).

Z<value> - Reset and Recall Stored Prole

Use this command to make the modem go on-hook and restore the prole saved by the last &W command.

Note: Both Z0 or Z1 restore the same prole

OK if <value> = 0—1.

_ ERROR if <value> 0—1.

Command Function

Z0 Reset and restore stored prole.

Z1 Reset and restore stored prole.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Nortel Networks ROADSTER 56K Bedienungsanleitung Seite 12