
112 Chapter 5 Managing the Passport 8672ATME Module with the CLI
209195-B
config atm pvc f5-oam command
This CLI command enables/disables and configures the F5-OAM Loopback
feature for a virtual circuit (VC). When this command is used for disabling the
F5-OAM Loopback on a VC, the configuration parameters are ignored. The
command uses the syntax:
config atm <slot/port> pvc f5-oam <vpi.vci> <enable|disable>
[send <value>] [retry <value>] [up <value>] [down <value>]
[trap <enable|disable>]
When this command is used for enabling the F5-OAM Loopback on a VC, the
other parameters configure the F5-OAM Loopback. When the F5-OAM Loopback
on a VC is already enabled, an enable command towards this VC may change its
F5-OAM Loopback configuration but it does not alter its F5-OAM statistics.
When the F5-OAM Loopback on a VC is disabled, an enable command towards
this VC enables and configures its F5-OAM Loopback, and clears its F5-OAM
Loopback statistics.
Table 39 describes the F5-OAM Loopback parameters.
Table 39 F5-OAM Loopback parameters
Configuration Default Values Description
<enable|disable> disabled Enable/Disable Enables/disables the F5-OAM Loopback feature.
send <value> 5 seconds 1..255 Sets the transmission rate (in seconds) of F5-OAM
Loopback requests. This field is also referred as
“send-frequency”.
retry <value> 1 second 1..255 Sets the retry-transmission rate (in seconds) of
F5-OAM Loopback requests. This field is also
referred as “retry-frequency”.
up <value> 3 responses 1..255 Set the number of consecutive F5-OAM Loopback
replies that must be received to change the
Loopback State to “up.” This configuration is also
referred as “up-count”.
Kommentare zu diesen Handbüchern