Nortel Networks AA1419005 Bedienungsanleitung PDF herunterladen (Seite 10)

Figure 3 Inserting a CWDM GBIC into the switching module

Removing a CWDM GBIC

Use the following procedure to remove a CWDM GBIC. When

storing a CWDM GBIC, place a dust cover over the fiber optic

bores

To remove a CWDM GBIC from the switching module:

1 Disconnect the fiber cable from the CWDM GBIC connector.

2 Grasp the extraction tabs (Figure 1) located on either side of

the CWDM GBIC between your thumb and forefinger.

3 Slide the CWDM GBIC out of the Gigabit Ethernet module

slot.

4 If the CWDM GBIC does not slide easily from the module

slot, use a gentle side-to-side rocking motion while firmly

pulling the CWDM GBIC from the slot.

Note: When disposing of a CWDM GBIC, comply with

all national laws and regulations

9708FA

1 2 ... 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Nortel Networks AA1419005 Bedienungsanleitung Seite 10