Nortel-networks Server 1005r Bedienungsanleitung PDF herunterladen (Seite 33)

Connecting peripherals to the server 33

To connect the modem to the server

Step Action

1 Connect one end of the telephone cable to the modem RJ-11 jack

labeled LINE.

Connect the other end of the telephone cable to the RJ-11 jack in

the wall.

3 Connect one end of the USB cable into the modem.

Connect the other end of the USB cable into either USB port 1 on the

rear panel (long term) or USB port 2 on the front panel (short term).

—End—

To connect the external SCSI tape drive

Step Action

Note : The external SCSI tape drive is a plug and play device. For a High

availability system you may wish to share one tape drive between the two

servers.

Set the SCSI ID dial switch on the tape drive to SCSI ID 6.

With the power switch off, connect the external SCSI tape drive to

the port labeled N on the rear panel. See "Rear panel connectors"

(page 31).

Plug the tape drive into the same single-point ground and A/C power

as the rest of the system.

Make sure the SCSI terminator is connected to the tape drive before

powering on the tape drive.

Power on the tape unit.

Nortel CallPilot

1005r Server Hardware Installation

NN44200-308 01.06 Standard

5.0 15 May 2008

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Keine Kommentare

Nortel-networks Server 1005r Bedienungsanleitung Seite 33