Nortel Networks Nortel Secure Network Access Switch 4050 Bedienungsanleitung PDF herunterladen (Seite 585)

100

101

Chapter 11 Managing certificates 585

Nortel Secure Network Access Switch 4050 User Guide

To verify that the current certificate number is not in use by an installed

certificate, use the

/cfg/cert #/show command.

2 Copy the certificate.

a In a text editor, open the certificate file you received from the CA.

b Copy the entire contents, including the

-----BEGIN

CERTIFICATE-----

and -----END CERTIFICATE----- lines.

If the certificate file contains the private key as well, also include the

entire contents of the key, including the

-----BEGIN RSA PRIVATE

KEY-----

and -----END RSA PRIVATE KEY----- lines.

3 Add the certificate.

a Enter the following command:

/cfg/cert #/cert

b Paste the certificate at the command prompt.

c Press Enter to create a new line, and then enter an ellipsis (

...) to

terminate.

d If you are pasting in the private key at the same time, and if the key has

been password protected, you are prompted to enter the password phrase.

The password phrase required is the one specified when the key was

created or exported.

4 Apply the changes.

If you obtained the certificate by using the

/cfg/cert #/request

command to generate the CSR and are using the same certificate number, the

certificate is now fully installed.

If you obtained the certificate by means other than using the

/cfg/cert #/

request

command to generate the CSR and are using a new certificate

number, you must now add the corresponding private key (see “Adding a

private key to the Nortel SNAS 4050 using the CLI” on page 587).

1 2 ... 580 581 582 583 584 585 586 587 588 589 590 ... 921 922

Kommentare zu diesen Handbüchern

Keine Kommentare

Nortel Networks Nortel Secure Network Access Switch 4050 Bedienungsanleitung Seite 585

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Nortel Networks Nortel Secure Network Access Switch 4050