Nortel-networks Sun Fire V100 Bedienungsanleitung PDF herunterladen (Seite 51)

MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide

11 Enter the <machine logical IP addresses of the

servers> that are the ping targets.

Note: Do not enter the IP address of the server you are

working on.

IP Multipathing needs a set of reliable hosts to ping against.

Select a set of three IP addresses in this subnet that belong to

reliable nodes (such as fault tolerant servers). Select the three

nodes from the following list, in order of preference:

For IPMP GROUPS:

• Machine Logical IP address of the database server

• Machine Logical IP address of the Management server

• Machine Logical IP address of the CAM server

• BPS stack IP address

• Other optional devices (Media Portal host, PRI Gateway

host)

Provide between two and six ping targets for each IPMP group

for proper IPMP failover reliability. Enter the address "0.0.0.0" to

indicate list is complete, if entering less than six targets.

Enter ping target #1: 47.104.27.202

Enter ping target #2: 47.104.27.217

Enter ping target #3: 47.104.27.205

Enter ping target #4: 0.0.0.0

Note: Do not use this server's own IP address as a ping

target.

You will need to press Enter after you enter each IP address.

12 Is this IPMP group configuration acceptable

(Y/N)

Select Y and press Enter.

13 The default route IP address should appear. If correct, press

Enter. Otherwise, type in the correct IP address, then press

Enter.

Note: If your configuration does not include a router, then

enter the machine logical IP address of your server.

14 You are now configuring the Syslog Daemon. [Enter]

15 Does the Management Server have a SysMgr Service Logical IP

Address [Y/N]? Select N.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 191 192

Keine Kommentare

Nortel-networks Sun Fire V100 Bedienungsanleitung Seite 51