Nortel Networks 24T Bedienungsanleitung PDF herunterladen (Seite 34)

Using the BayStack 410-24T 10BASE-T Switch

1-6

309985-B Rev 00

Back Panel

This section describes the BayStack 410-24T switch back panel components

(Figure 1-4

Descriptions of the back panel components follow the figure.

Figure 1-4. BayStack 410-24T Switch Back Panel

This automatic process is a temporary safeguard only. If

the stack configuration loses power, the temporary base

unit will not power up as the base unit when power is

restored. For this reason, you should always assign the

temporary base unit as the base unit (set the Unit Select

switch to Base) until the failed unit is repaired or replaced.

Link 10 Mb/s port

speed indicator

Green On The corresponding port is set to operate at 10 Mb/s and

the link is good.

Green Blinking The corresponding port has been disabled by software.

Off The link connection is bad or there is no connection to

this port.

Activity Port activity Green Blinking Indicates network activity for the corresponding port. A

high level of network activity can cause the LEDs to

appear to be on continuously.

Table 1-1. BayStack 410-24T Switch LED Descriptions

(continued)

Label Type Color State Meaning

Cascade Module

= AC power receptacle

= RPSU connector

= Cascade Module Slot

BS41004A

100-240V~

47-63HZ~

1.5A-600ma

Redundant Power

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 309 310

Keine Kommentare

Nortel Networks 24T Bedienungsanleitung Seite 34